3/8" M BSP x 3/8" M BSP Pump Fitting with Filter Housing

3/8" BSP Pump Fitting with Filter Housing

A 3/8" male BSP x 3/8" male BSP brass fitting with a recessed pocket machined into one end to hold an inline filter screen, it mounts right at the pump inlet to keep grit and scale flakes out of the pump. CMA part #25732.

SPECIFICATIONS

• 3/8" male BSP x 3/8" male BSP
• Recessed housing accepts filter screen W5197

COMPATIBILITY

• Fits: CMA-built machines (Astoria, Bravo, Formula, Rio, Wega) and other equipment using a 3/8" BSP pump inlet
• Replaces: CMA part #25732
• Works with: filter screen W5197 (sold separately)

INSTALLATION

An easy DIY swap, thread it in by hand and snug with a wrench, no special tools required.

PRO TIPS

• Don't leave the recessed pocket empty, without the W5197 screen seated inside, you lose the filtration this fitting exists for, and debris can find its way straight to the pump.
• BSP parallel threads seal on the flat face/washer, not on thread compression, snug it down until it's seated against its sealing washer, then stop; overtightening won't improve the seal and can crack the housing.