NPET Replacement Pump for WF100 Cat Water Fountain

★★★★★ 4.2 65 Bewertungen

€5.60
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Verkauft und versendet von aiignitestudio.com
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€5.60
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Wie möchten Sie Ihren Artikel erhalten?
Die ersten 30 Tage sind kostenlos! Wählen Sie den Tarif an der Kasse.
Versand
Ankunft 12.09.
Kostenlos
Abholung
In der Nähe prüfen
Lieferung
Nicht verfügbar

Verkauft und versendet von aiignitestudio.com
30 Tage kostenlose Rückgabe Details

Produktdetails

Artikelnummer 235128123 Erscheinungsdatum 2026/07/02 Listenpreis €5.60 Modellnummer 235128123
Kategorie
  • Only compatible with NPET WF100 automatic cat drinking fountain.Warranty is 1 year/12 months warranty. Pls contact us via order page for any quality problem.
  • Bottom Suction Pump: This is an ultra-quiet, low-consumption pump. Noise level is measured below 40 dB, provide you and your cats a quiet environment.
  • In addition, the pump is designed for use with low water levels: This pump’s water inlet is close to the bottom of the tank to keep water circulating all around. So there is no dead water and always provides fresh water to your pets!
  • Cord Length: 1.5m/4.9 ft Cord. USB supply is available for the 5V, 1A adapter.
  • Note: Please clean the pump every 2 weeks to extend the life of the pump. The pump can be used for 2.-3 years. We found that 99% of the pumps can be reused after cleaning by analyzing the returned products from customers. We advocate environmental protection and discourage our buyers to purchase new ones. You can get the cleaning process from the video on the product page. Thank you for your understanding.


Pump Cleaning Steps:

1. Remove the faceplate. You may need to use a fingernail to pry it off.

2. Remove the yellow, teardrop-shaped stator by pulling up on the small tab.

3. Use a fingernail to pull out the impeller, which is held in place magnetically. Clean the pump parts with clean water, then reassemble.


Korrektur der Produktinformationen

Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.

Korrekturanfrage

Kundenbewertungen

4.2 von 5
★★★★★
65 Bewertungen | 27 Rezensionen
So wird die Artikelbewertung berechnet
Alle Bewertungen anzeigen
5 Sterne
78% (51)
4 Sterne
6% (4)
3 Sterne
3% (2)
2 Sterne
2% (1)
1 Stern
11% (7)
Sortieren nach

Für dieses Produkt liegen derzeit keine schriftlichen Bewertungen vor.