Small Solenoid Voltage Connector

Solenoid Voltage Connector

A voltage connector for solenoid coil wiring. Not the same as the flowmeter connector (V_377), the terminal spacing is different. The inner core can be removed and rotated to position the terminal slots as needed.

SPECIFICATIONS

• Terminal slot spacing: 12 mm
• Ground wire slot: 12 mm above terminal slots

COMPATIBILITY

• Works with: solenoid coil wiring
• Not interchangeable with the flowmeter connector (V_377), different terminal spacing

INSTALLATION

Moderate DIY, loosen the fixing screw, remove the connector and moisture protector from the coil, draw back the wire restraint nut, gently pry out the center insert, note your original wire color and position relative to the ground slot, then reverse the process to install the new connector.

PRO TIPS

• Before disconnecting the old connector, photograph or note which wire color sits on which side of the ground terminal slot, the replacement insert needs to go back in the same orientation or you'll cross the wiring.
• Don't confuse this with the flowmeter connector (V_377), the terminal spacing is different (12 mm here vs. 9.5 mm there), so the two aren't interchangeable even though they look similar.