32x25-45MM Hot Runner Heater Plastic Extruder Heating Coil Element 1M Wire with K Thermocouple 110V/220V 300W-600W 1PC

32x25-45MM Hot Runner Heater Plastic Extruder Heating Coil Element 1M Wire With K Thermocouple 110V/220V 300W-600W 1PC1. Material:Stainless steel2.Voltage: 110V/220V3.ID*H:32X25mm 32x30mm 32x35mm 32x40mm 32x45mm 4.Wattage:300-600W 5.Cross section: 3x3mm/4.2x2.2mm/3.5x3.5mm6.With thermocouple: Yes,K type,(if you need J/E type,please contact us)7.With Grounding wire:Yes8.Lead Wire: 1M length9.Temperature Range:0-50010.Package:1PC hot runner coil heater according to you choosePay attention: Power Allowance-10%~+5%Application:1. Product features: This product has the advantages of easy installation, fast heat transfer, good insulation, and production not limited by models and specifications,long service life and is not easily burnt out2. Product use:Widely applicable to injection molding machines, vacuum molding machines, drying machines, sheet metal machines, and bottle blowing machines...Different specifications can be customized according to your requirements!Installation and Use01. Before installation, use a multimeter to test whether the heating coil is powered on. If there are no issues with the measurement, then install it. If the measurement is not powered on, please contact wih us.02. The heating ring must be in close contact with the mold. The tighter the contact, the higher the thermal efficiency and the faster the heating rate.03.When wiring, make sure to tighten it. After tightening, it is best to forcefully pull down the power cord by hand, otherwise poor contact may cause ignition and trippingOrigin : Mainland ChinaType : Electric Water Heater PartsProduct Name : Hot runner coil heaterMaterial : stainless steelInner Diameter : 32mmHeight : 25-45mmWire Length : 1MPower : 300-600W

• Treayes 32x25-45MM Hot Runner Heater Plastic Extruder Heating Coil Element 1M Wire with K Thermocouple 110V/220V 300W-600W 1PC